The compact size of our Half Moon Pot Rack makes it very easy to fit in small wall spaces. The unique half moon shape will add style to your kitchen. It's extra handy too, because it features a rear bar that holds several utensils. Position rack in drywall anywhere you like. Includes 8 convenient pot hooks. 16"H x 7"W x 14"L
Half Moon Pot Rack

TOOLS PROVIDED: Hex wrench, fastener hardware (anchor, nuts, bolts, screws and sleeves)

TOOLS NEEDED: Level, tape measure, pencil, drill and 1/2" drill bit, hammer and nail

parts list

assembly diagram


TIP FIRST, REMOVE PAINT FROM BOLT HOLES. Because the powder coat finish applied at the factory also adheres to the inside of bolt holes, pushing a bolt through it during assembly may be difficult. Therefore, before connecting parts, we recommend that you clean out screw holes in body (4B) and back bar (11). Using a button head bolt and hex wrench provided, rotate the bolt through each screw hold, then withdraw it. That will push paint out and make attaching parts easier.

  • STEP 1: Layout Parts On a table lay out all parts as shown in the view above.

  • STEP 2: Connect Main Body Parts Connect half circle (4B) and back bar (11) by inserting button head bolts (18B) through all screw holes. Be certain back bar is on the INSIDE when connected.

  • STEP 3: Attach Arm It is easiest to attach arm when the corner of the pot rack to which you are connecting the arm hangs slightly over the edge of the table. That provides clearance for the flared end that extends below the body of the rack. Align arm (6) over two holes at front of half circle (4B) and connect with two button heads (18B). Do not tighten bolts firmly until all bolts are in place.

  • STEP 4: Level Pot Rack on Table Place assembled rack squarely on table and adjust all parts to be certain they are level and straight. Then tighten all bolts firmly.

  • STEP 5: Measure For Wall After the rack is squared and tightened, the position of the three anchor points (a triangle) is 11" high by 11-1/4" wide. Use this measurement when determining location of rack on wall in installation section below.


    Decide where you want to place your pot rack. We suggest a location near your stove, sink or food preparation area. Also consider the height of the wall where the pot rack will hang, keeping in mind how far below the rack your pots and utensils will hang. On the wall, mark the three points 11" long by 11-1/4" high (a triangle) where the top of rack arm and back bar will attach. Then tap a small nail through each mark to be certain a stud is not in the way. (NOTE: because your pot rack includes super-strong new-technology anchors, you DO NOT need to locate and bolt to studs. See more information under STEP 2 BELOW).

    The steel anchors are very strong and when installed in 5/8"drywall (standard ceiling code in modern houses) each drywall anchor holds about 200 lbs; many times the weight you will likely hang from your pot rack. SEE TOGGLE INSTRUCTIONS BELOW

    drywall installation guide