Hardware: (4) Bolts (4) Wing Nuts (4) Washers
|
* |
To assemble the table, screw the end of the bolt with the wide threads into the pre-drilled hole into the leg by hand. |
* |
To tighten the bolt, screw one wing nut upside down and another right side up onto the end with the finer threads until tight. (Fig. 1) |
* |
Using downward force while turning, screw the bolt into the leg with 3 full turns. |
* |
Remove the wing nuts and repeat process for the rest of the legs. |
* |
Remove the drawer(s) from the table. |
* |
Turn table upside down on a smooth surface. |
* |
Attach the leg to the corner of the table, sliding the bolt through the pre-drilled holes. |
* |
Install flat washer and wind nut, then tighten securely. |
* |
It is tight enough when a 1/2" of fine threads show past the wing nut. (Fig. 2) |
* |
If table has a shelf, insert shelf into grooves in 3 of the attached legs, then install final leg. |
Please call our Customer Service Department
1-800-231-8060
M-F 8am - 9pm and Sat 9am - 6 pm
if you have any further questions.
|